arduino

Sequencial led chaser Project for beginers using Arduino

Sequencial led arduino
Sequential Led chaser

In this Arduino project, I am gona show you how to make 10 Led chaser using arduino.

For making this project we require some components and a software for uploading code on arduino board.

Required Software

Arduino IDE

arduino
arduino |image-google

Required Components

ComponentQuantityBuy Link
1. Arduino Uno 1 Link
2. Color LED 10 Link
3. 100Ω Resistance 10 Link
4. Jumper Wire as require Link
5. Breadboard 1 Link

For this project I am using arduino uno and basic components. everyone know what is an Arduino, If you don’t know don’t worry I will tell you,

What is an Arduino

Arduino is a micro-controller device or an open source platform that is able to read inputs from sensors, buttons, lights and turn it into an output for activating a motor, turning on an LED, turning on bulb, sending messages. You can tell your board what to do by sending an instructions to the microcontroller on the board. 

Arduino Uno
Arduino Uno

Lets start the making this project, for making this project we mobilize all the components.

Connect all the wires that are shown in the figure

Wiring Diagram

sequential led wiring diagram
wiring diagram
  • Connect all the led with arduino digital pin (2,3,4,5,6,7,8,9,10,11)
  • All led have a separate 100Ω resistor
  • Connect all the cathode pin of led to ground of the arduino

After making connection download the code.

Now and arduino IDE and paste the code into codee editor.

connect the arduino into computer from USB cable and select the Board and Port

arduino ui
Board and Port

Select Board: “Arduino/Genuino Uno” and Port: “COM15 “

Now verify and upload the code, for uploading click on the arrow icon

That’s It Now your 10 led sequential chaser is done

led chaser arduino
Sequencial led arduino

Leave a Reply

Your email address will not be published. Required fields are marked *